Q: I have the base built but cannot fire the Toyan v8 gas engine. There are 2 different firing orders in the instructions. Which one do I need to use? And do you have better instructions for the fitting of the magnetic collar? Should I be using the slotted holes or fixed holes in the collar?
.I have noticed that all spark plugs fire at the same time from both Cdi units. All 8 plugs fire at once. Should it be firing 4 at 0 and 180 degrees and the other 4 at 90 and 270 degrees on the magnetic collar?
Should all spark plugs fire at the same time? I have a few puffs of smoke but only from one side of the exhaust.
Also Is there a base setting for the carburetor?
A:
Use this firing sequence for the flywheel collar. Screw the oil needle of the carburetor all the way to the end, and then withdraw it for 2 and a half turns, and open the damper by 1/3 or 1/4 to try to start.
Related Topics You Might Want to Know About Toyan V8 FS-V800WGPC
Youtuber Liumutou’s Toyan V8 Model Engine Guide: What First-Time Builder
Toyan FS-V800WGPC vs. FS-V800G: What Makes the New Model Stand Out | Stirlingkit
Ultimate FAQ on Gas Toyan V8 Engine FS-V800G Small Block V8 Kits | Stirlingkit
The latest progress Toyan V8: 100% production completed | Stirlingkit
If You Had This Toyan V8 Engine, What Project Would You Use It For? | Stirlingkit
A Letter from Toyan: Why Toyan V8 FS-V800WGPC is Worth a Second Look | Stirlingkit
Toyan V8 FS-V800EWG 2024 Update: All You Need to Know About! | Stirlingkit
16 Frequently Asked Questions about Toyan engines | Stirlingkit
Why do we Made a New Gas Toyan Engine FS-V800G in 2024? Product Designer at Toyan Say | Stirlingkit
Top 12 Common Mistakes that Toyan V8 Engine Owners Make | Stirlingkit
Toyan Releases A Gas V8 Engine FS-V800G Today | Stirlingkit
All You Need To Know About The Legendary Toyan V8 Small Block Motor FS-V800 | Stirlingkit
Wait? Toyan Engine New Look? Amazing!
where do i buy the sensor?
I bought mine in sept.2023 and i still cannot get it started. Parts keep breaking!!!. Can’t get any help from anybody!!. What a big waste of money. JUNK JUNK JUNK. THANKS ALOT
I need help on the circuit board wiring from the induction pickup on the camshafts.
Two questions:
1. What does the last column in the table with entries of 1-4 or 2-3 mean?
2. How is the timing set? Diagram shows 30 deg. counterclockwise rotation of flywheel collar. Is there a specific piston position or crankshaft position that corresponds to this sensor position? If so, what is it?